February 2020
Columns
Reliability: Consider successful pump redesigns: Start with a clean sheet of paper
You may recognize the “pre-owned” pump in FIG. 1 as an axially split, between-bearing, multistage model. Chances are that half of its impellers face right-to-left and half of them face left-to-right. In that case, there must be an internal seal or bushing that limits leakage flow from the pump’s higher- to lower-pressure sections. There must also be porting or piping that takes flow from the discharge of the lower-pressure section to the suction of the higher section.
The Author
Heinz P. Bloch resides in Montgomery, Texas. He retired as Exxon Chemical’s Regional Machinery Specialist for the U.S. and has authored or co-written more than 780 publications, among them 23 comprehensive books on practical machinery management, failure analysis, failure avoidance, compressors, steam turbines, pumps, oil mist lubrication and optimized lubrication for industry. Mr. Bloch holds BS and MS degrees (cum laude) in mechanical engineering from the Newark College of Engineering (NCE). He is one of 10 inaugural inductees into NCE’s Hall of Fame, which honors its most distinguished alumni.
Related Articles
- Improve sour water stripper unit performance via feed sour water preconditioning
- Causes and countermeasures for a compressor lube oil system failure due to delayed oil pressure recovery by an auxiliary lube oil pump
- Application of systems engineering principles in a reliability assessment of air-cooled heat exchangers
Comments