Boilers
BETE obtains ASME code certification for boilers, pressure vessels
BETE is the first spray nozzle company to obtain these ASME and National Board stamps.
Consider new steam system corrosion protection for refineries
New technology in volatile filming corrosion inhibitors and lower-salting neutralizing amines can provide cost-effective solutions for the steam-condensate system and minimize the risk of amine chloride salt formation.
Case study: Service life assessment of boiler superheater tubes
Boilers are used in petrochemical facilities to generate steam that can be used to meet process and utility requirements. Many industrial boiler designs can be shop assembled and are therefore referre..
Inspect steam reformers and catalyst tubes with infrared thermography
Infrared thermography is a useful inspection tool to help locate problems in steam reformers while the units are online and fired. There are three main areas in a reformer that can be efficiently insp..
HP Water Management: Best practices for RO operations
Widespread use of reverse osmosis (RO) technology in industrial applications began in the late 1980s, following the introduction of polyamide materials that had a significantly higher permeate flow an..
Mitigate fouling in crude unit overhead—Part 3
CASE STUDYThe basis for this case study is shown in Fig. 18; it is a crude unit with overhead heat integration. This is a one-drum overhead system with heat integration and no water wash. In an attemp..
Improve pressure drop calculations for saturated water lines
When saturated water flows through pipes and components, it flashes—thus increasing its specific volume and limiting the fluid flowrate. Due to these conditions, the calculation and design for pi..
Achieve uniform heat flux in a coker furnace
A delayed coker unit thermally cracks vacuum residue (VR) and converts it into products like liquefied petroleum gas (LPG), naphtha, gasoil and petroleum coke. A majority of the thermal cracking takes..
Optimize amine units and improve refinery profitability
The alkanolamine system in a refinery, better known as the amine unit, is used to remove hydrogen sulfide (H2S), carbon dioxide (CO2) and mercaptans (collectively referred to as acid gases) from proce..
Optimize crude preheat train to balance efficiency and operability
Critical attention must be paid when designing the crude distillation unit (CDU) preheat train. Many pitfalls can easily lead to unnecessary expenditures or unsatisfactory operations. Key design crite..
- Perpetual Next appoints Bilfinger as lead consultant for its Methanol Moerdijk project 4/1
- ASRock Industrial and CSI Validate O-PAS™ Systems Management Architecture with the iEP-7020E and AiSMA 4/1
- Heavy equipment for KazMunayGas' Atyrau PE plant ships from Shanghai to Kazakhstan 4/1
- KT Tech awarded early engineering works contract for 60,000-tpy SAF plant in Indonesia 4/1
- OCI Global completes sale of OCI Ammonia Holding to AGROFERT 4/1
- Union workers ratify contract at ExxonMobil's Louisiana (U.S.) refining and chemical complex 4/1
