Environment & Safety Gas Processing/LNG Maintenance & Reliability Petrochemicals Process Control Process Optimization Project Management Refining

Maintenance & Reliability

Pump aftermarket offers solutions for abrasive services

Sulzer Pumps (US) Inc. Service Center Houston: McPherson, S.

Upgrades substantially increased MTBR

HP Reliability: Consider bearing protection for small steam turbines

Hydrocarbon Processing Staff: Bloch, Heinz P.  |  Thinnes, Billy

In most small machines there is a need to limit both contaminant ingress and oil leakage. Inexpensive lip seals are sometimes used for sealing at the bearing housing, but lip seals typically last only..

ITT acquires Canberra Pumps in Brazil

ITT Corp. has acquired Canberra Pumps do Brasil, expanding the company’s pump manufacturing presence in the Latin America region. Canberra Pumps has an installed base of 20,000 pumps serving customers in the chemical, pulp and paper, and general industry pump markets.

Diamond-coated seals extend pump life

Although problem-free pump operation is the primary goal of all pump operators, achieving that goal is not a simple matter. The key components of a pump - mechanical seals, impellers, couplings, roller bearings and housings – are all subject to wear.

Case 57: Troubleshooting the cause of sudden impacts

Consulting Engineer: Sofronas, A.

Finding the cause can be elusive but calculations help

HP Reliability: Not ready for 29-year-old pump packing

Hydrocarbon Processing Staff: Bloch, Heinz P.

In 2009 we were informed about “a nuclear plant that was never commissioned after its original construction. This plant has been sitting idle for 29 years and is only now starting up.” The o..

Furnace tubes-enhancing safety and efficiency with infrared thermography

Thermal imaging offers advantages over thermocouples

Troubleshooting waste-heat boiler poor heat transfer

Saudi Aramco: Yeh, G. J.  |  Al-Babtain, I.  |  Al-Zahrani, S.
PetroRabigh: Al-Ghanemi, N.

Analytical results showed that potash leached from the catalyst, refractory powder, corrosion products and, to a lesser extent, catalyst fines resulted in tube fouling

Purging and inerting large-volume tankage and equipment-jet mixing concept-Part 2

Carmagen Engineering, Inc.: Gollin, M.

Recommendations for the design, installation and testing of jet mixing systems

Case 56: Quick troubleshooting of shaft failures

Consulting Engineer: Sofronas, A.

Some simple calculations can guide the way to improved performance